It based on the elastic contact mechanics, the hardness test method is used, which has the advantages of non-destructive and can test the mechanical properties of materials in a small local range.Īfter decades of development and application, the residual stress testing technology has formed a variety of different detection technologies. The method includes magnetic memory method, magnetic strain method, Barkhausen Noise(BN) and Magnetomeehanieal Aeoustic Emission(MAE). Nanoindentation technique was proposed and developed by Olive et al. The basic principle of magnetic measurement is to use the magnetostrictive effect of ferromagnetic material to measure the stress. In the Raman spectroscopy method, the stress inside the crystal can be accurately calculated according to the relationship between stress and relative Raman shift. Ultrasonic stress measurement is based on the theory of acoustic elasticity, using the phenomenon of acoustic birefringence in stressed materials, which is one of the most promising technologies in the development direction of residual stress nondestructive testing. When the Bragg diffraction occurs, the diffraction peak is moved due to the residual stress, and the residual stress can be obtained by the corresponding formula. Physical methodsĭiffraction method is the most widely used and most mature technology in nondestructive testing technology, including X-ray diffraction, neutron ray diffraction and X-ray synchrotron radiation. In addition, there is a chemical reagent that qualitatively studies the magnitude and type of residual stress based on the time of occurrence of the crack and the time of weight reduction. In mechanical methods, the residual stress is measured by the stripping method of milling, but the milling process brings errors, and the chemical milling method perfectly solves this problem. Chemical methodsĬhemical methods are rarely used in residual stress measurement. In addition, there are other new methods, such as the crack compliance method based on the principle of linear elastic fracture mechanics and the most accurate destructive detection technique-contour method. In order to measure the residual stress distribution along the depth direction, the workpiece can be removed layer by layer by the stripping method, and the residual stress distribution can be obtained by measuring the strain value using the formula. It is widely used in residual stress testing of turbine and turbo generator rotor forgings and has established corresponding standards. The principle of the ring-core method is similar to the hole drilling method, and the stress in the measured area is released by processing a circular groove. In order to reduce the operational error and other factors in the measurement, the test method using the non-contact measurement of the strain method combined with the drilling method has been rapidly developed, such as Electronic Speckle Pattern Interferometry (ESPI) using optical measurement strain. American Society for Testing Materials (ASTM) has developed a standard assay techniques residual stresses drilling method. The method generally uses strain gauges to measure the strain data after drilling in the tested area, which has the advantages of simple operation and low test cost. The hole drilling method is one of the most common surface residual stress testing methods. The comparison of residual stress test methods is as follows : Comparison of residual stress test methods Classification of specific measurement methodsģ. Regardless of the method, the residual stress can only be calculated by indirectly measured quantities such as strain or displacement. Therefore, the detection and evaluation of its status is extremely important in industrial production.Īt present, residual stress measurement methods can be generally divided into two categories, one of which is destructive detection method, including mechanical methods and chemical methods, the principle is to remove some or all of the materials in some way, measure the strain or displacement of a specific area, and according to mathematical inversion of residual stress is performed for specific boundary conditions. The other category is non-destructive testing method, which is mainly tested according to the physical properties of the material, that is, the physical method. On the other hand, compressive stresses are sometimes introduced deliberately, as in shot peening which is used to improve fatigue resistance. Indeed, it is one of the main factors affecting the machining accuracy and strength of the workpiece, which is very unfavorable to the performance of the material or the life of the component. Residual stress remains in a body which is stationary and at equilibrium with its surroundings.
0 Comments
Leave a Reply. |